 The LanScaper™ is a jack identifier, cable tester, length measurement device, and ping tester in one unit.
The easy-to-use LanScaper enables quick identification at unknown RJ45 jacks for active Ethernet, POTS, Token Ring, or other devices. It pings network devices to verify connections and IP addresses, automatically accessing DHCP hosts to obtain network information.The LanScaper can quickly identify hubs, NICs, or auto MDI/MDI-X devices and conduct link tests to identify speed and capabilities of network drops.
For cable testing, the LanScaper provides full cabling testing, displaying wire map, ID, and faults, including shorts, opens,miswires, split pairs, and reverses.The fullfeatured LanScaper also measures cable length and generates tone levels for signal tracing and cable identification on all pairs, a selected pair, or a selected pin.
Key Features
• Detects and reports speed and capabilities for active Ethernet and other devices up to 100 Mb/s
• Pinging function verifies connectivity to network devices
• Blinks link indicator to identify cable termination on active ports
• Identifies hubs, NICs or auto MDI/MDI-x devices
• Tests cabling configuration and verifies connectivity while conducting tests for opens, shorts, miswires, split pairs, and reverses
• Displays length measurement for each pair in feet or meters
• Generates selectable tones on selected pins for use with tone tracers
Applications
• Network testing for port discovery, ping test, and hub flash
• Identifies speeds up to 100 Mb/s, duplex mode, and other capabilities of active Ethernet devices
• Conducts full cable tests with display of PASS, wiremap, ID, and faults for telco, data, and coax cable
• Measures cable length
• Tones and traces cables
• Wiremaps network connections with remote identifiers
|
| |
| Manufacturer.....................: |
 |
 |
|
|
|
| Product Detail.....................: |
NT700 ... LanScaper Cabling and Network Tester with cable test remote. Includes two 30.48 cm (1 ft) RJ45 to alligator clips cables, two 30.48 cm (1 ft) patch cables with RJ45 connectors, two 19 cm (7.5 in) RJ12 to RJ12 cable for no-fault connection to RJ11 or RJ45 jacks, nylon case, and 9-volt battery
NT750 ... LanScaper Cabling and Network Tester Kit with 8 remote identifiers. Includes Tone Tracer Probe, two 30.48 cm (1 ft) RJ45 to alligator clips cables, two 30.48 cm (1 ft) patch cables with RJ45 connectors, nine 19 cm (7.5 in) RJ12 to RJ12 cables for no-fault connection to RJ11or RJ45 jacks, two RJ45 to coax F connector adapters, nylon case, and 9-volt battery |
| Specification Data Sheet....: |
Click Here |
|
|
| |
| |
|
|
| |
|
|
|
| |
|